ASSEMBLY
NOTE: This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed.
nInspect the tool carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
nIf any p arts ar e d amaged o r m issing, p lease c all
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose Trigger Handle Holder Trigger Handle
Screw
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could r esult in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this pr oduct. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the enginespark plug wire from the spark plug when assembling parts.
RAISING AND LOWERING THE HANDLE
See Figure 2.
nTo raise the handle (for moving the pressure washer): pul the handle up until the handle release knob snaps into locking position. Ensure the lock is secured in the frame hole before moving.
nTo lower the handle (for storing or transporting the pres- sure washer): pull the handle release knobout and lower the handle to the down position.
NOTE: The handle can not be locked in the down posi- tion.
Never use the handle tolift the pressure washer. The handle should only be used for moving the unit by r olling it on its wheels.
INSTALLING HOSE STORAGE, TRIGGER HANDLE HOLDER, AND SPRAY WAND HOLDER
See Figures 3 - 4.
nRaise handle as described in the Raising and Lowering Handle section.
nPlace hose storage onto the handle as shown.
nAlign the holes in the hose storage with the holes in the handle.
nInsert bolt
nPlace nut onto bolt and tighten.
nPlace the trigger handle holder onto the handle as shown.
nAlign the holes in the trigger handleholder with the holes in the hose storage and the handle.
nInsert bolt
nTurn bolt while holding the nut in place to tighten and secure.
nPlace spray wand holder onto pressure washer frame.
nAlign the holes in the spray wand holder with the holes in the pressure washer frame.
nInsert screw
nPlace nut onto screw and tighten.
ASSEMBLING THE SPRAY WAND TO THE TRIGGER HANDLE
See Figure 5.
nPlace the threaded end of the spray wand in the connector on the end of the trigger handle.
nTurn the connector clockwise until it stops.This secures the spray wand in place.