TROUBLESHOOTING
PROBLEM |
| CAUSE | SOLUTION |
Engine fails to start | No fuel in tank |
| Fill tank |
| Spark plug shorted or fouled | Replace spark plug | |
| Spark plug is broken (cracked | Replace spark plug | |
| porcelain or electrodes broken) |
| |
| Ignition lead wire shorted, broken, or | Replace lead wire or attach to spark plug | |
| disconnected from spark plug |
| |
| Ignition inoperative | Contact authorized service center | |
Engine hard to start | Water in gasoline | Drain entire system and refill with fresh fuel | |
| Weak spark at spark plug | Contact authorized service center | |
Engine lacks power | Dirty air filter |
| Clean or replace air filter |
Detergent fails to mix with spray | Detergent injection hose is not properly | Insert injection hose into detergent | |
| submerged |
| container or detergent bottle |
| Spray selector on the | Rotate the spray sel ector on th e 5 | |
| Over Nozzle is set to either the [40º], | Change Over Nozzle to either the Soap | |
| [25º], or [0º] setting | Short Range [ ] or Soap Long Range [ ] | |
|
|
| setting |
Pump doesn’t produce pressure | Spray s elector o n t he | Rotate the spray sel ector on th e 5 | |
| Over Nozzle is set to either the Soap | Change over Nozzle to either the [40º],[25º], | |
| Short Range [ | ] or Soap Long Range | or [0º] setting |
| [ ] setting. |
|
|
| Inadequate water supply | Provide adequate water flow | |
| Trigger handle or spray wand leaks | Check connections and / or replace trigger | |
|
|
| handle or spray wand |
| Nozzle is clogged | Clean nozzle | |
| Pump is faulty |
| Contact authorized service center |
| Air in line |
| Squeeze trigger on trigger handle to |
|
|
| remove air from line |
Machine doesn’t reach high | Diameter of garden hose is too small | Replace with 3/4 in. garden hose | |
pressure |
|
|
|
| Water supply is restricted | Check garden hose for kinks, leaks, and | |
|
|
| blockages |
| Not enough inlet water | Open water source full force | |
| Spray s elector o n t he | Rotate the spray sel ector on th e 5 | |
| Over Nozzle is set to either the Soap | Change Over Nozzle to either the [40º],[25º], | |
| Short Range [ | ] or Soap Long Range | or [0º] setting |
| [ ] setting. |
|
|