~
MAINTENANCE
Installation
1. With the seat raised and locked, install the battery in the
compartment. The battery terminals should face the rear.
2. Install the positive (+) cable on the battery positive (+) terminal;
then install the negative (-) cable on the battery negative (-)
terminal, then lower and lock the seat.
Fuse Replacement
The fuse and fuse holder are next to the positive (+) connector near
the battery. The lawn tractor will not start if the fuse is blown. To
replace the fuse:
1. Turn the ignition switch to OFF, then raise and lock the seat.
2. The fuse used in the lawn tractor is a blade type. Grip the edge of
the fuse with one hand
and the fuse holder with FUSE: 5 AMPS
the other. Pull the fuse
straight out of the holder.
3. A blown fuse is indicated
by a broken link, visible
between the two blades
on the fuse. Discard a
i’72MMAACDR
blown fuse, and replace it
with one of the same rating (5 amps).
4. If fuse failure occurs, determine the
cause, and correct the problem before
operating the lawn tractor further.
piEq
@
GOOD BLOWN
?iVMAAAA.CDR
Never use a fuse with a different rating from that specified. Serious
damage to the electrical system or fire may result.
73