MAINTENANCE
INSPECTING FOR A BENT BLADE
Perform this inspection prior to attempting any mower deck leveling
adjustments.
1. Wearing heavy gloves, position the right
(discharge) side blade so it is parallel to the
front axle.
2. Measure the height of the right side blade at
point B and record this measurement.
3. Rotate the right side blade 180 degrees and
measure the other tip at point B.
4. The two measurements should be the same;
if they are not, the blade or blade spindle may
be bent.
5. Repeat steps 1 - 4 for the left side blade but ?71 BAhAA.CDR
measure at point A.
BLADE BOLT TIGHTNESS
Blade bolt tightness should be checked as specified in the
Maintenance Schedule (page 58).
{ 4 -
The blades are sharp, and they spin at
high speed during operation.
Contact with a moving blade can cut
you severely and can amputate fingers.
Before working on or near a blade,
always disengage the PTO, and
remove the ignition key to prevent
accidental starting. Wear heavy gloves
to protect your hands. Disconnect the
spark plug cap.
1. Remove the mower deck from the lawn tractor; see page 77.
2. Put on heavy gloves and turn the mower deck upside down.
82