Front Corner Baffle Installation (figure 2)
Attach front corner baffle (5) up under mower frame as shown and attach with bolts (8) and flange lock- nuts (9).
Ensure both slde skids, the left side shield and elther the dkcharge chute or rlght slde shleid are installed.
Right Side Shield & Baffle Installation
(flgure 2)
FRONT CORNER
INSTALLATION
INSTALLATION
INSTALLATION
1.Mower frame
2. Right side skid | D83052A |
|
3.Discharge chute
4.Right side shield
5.Front corner baffle
6.Side shield baffle
7. 3/8 x 1" Bolt
8.3/8 x 3/4" Carriage bolt
9.3/8" Flanged hex locknut
10. 3/8" Lockwasher
11. 3/8" Hex nut
Figure 2. Right Skid, Shield & Discharge Chute
When right side shield (4) is installed, you must | ~~ | I |
install side shield baffle (6). Attach rear portion of |
| |
baffle (6) to mower frame with bolt (8) and flange |
|
|
locknut (9) as shown. Attach front end of baffle (6) |
|
|
to side shield (4) with bolt (8) and flange locknut (9) |
|
|
as shown. Attach side shield (4) to mower frame |
|
|
with bolts (7) and flange locknuts (9) as shown. |
|
|
Discharge Chute Installation (figure 2)
The discharge chute (3) may be installed in place of baffle (6) and side shield (4). Attach discharge chute
(3)to right side of mower with bolts (7)and flange locknuts (9) as shown.
Right Side Skid Installation (figure 2)
The right skid (2) also serves as a guard. Do not operate mower unless it is in place and in good condition.
Attach right side skid (2) to mower frame (1) as shown with bolts (7), lockwashers (10) and nuts (11). Do not tighten this hardware as the skid will require adjustment when cutting height is set.
Caster Arm Installation (figure 3)
1.Mower frame
2.Caster arm
3. Adjustment bracket | D m 1A |
4.1/2 X
5.1/2 x
6.1/2" Flanged hex locknut
Figure 3. Caster Arm Installation
10 |
