2.With snap rings removed, support drive in vise, hold yoke in hand and tap on yoke to drive cup out of yoke. See figure 20.
4.Place universal cross in vise'as.shown in figure
22and tap on yoke to remove cup. Repeat step three for final removal. Drive remaining cup out with drift and hammer.
082513
Figure 20
3.Clamp cup in vise as shown in figure 21 and tap on yoke to completely remove cup from yoke. Repeat steps two and three for opposite cup.
M
DB2514
Figure 21
Figure 22
Assembly
1.Place seals securely on bearing cups. Insert cup into yoke from outside and press in with hand pressure as far as possible. Insert journal cross into bearing cross with grease fitting away from shaft. Be careful not to disturb needle bearings. Insert another bearing cup across from first cup and press in as far as possible with hand pressure.
Trap cups in a vise and apply pressure. Be sure journal cross is started into bearings and continue pressure with vise, squeezing in as far as possible. Tap yoke to aid in process.
2.Seat cups by placing a drift (slightly smaller than the cup) on cup and rapping with hammer. (See figure 23.) Install snap ring and repeat on opposite cup.
25 |
