![](/images/backgrounds/160494/160494-19254x1.png)
Output Sequence Editor
This programming selection allows you to program the scanner to output data (when scanning more than one symbol) in whatever order your application requires, regardless of the order in which the bar codes are scanned. Reading the Default Sequence symbol programs the scanner to the Universal values, shown below. These are the defaults. Be certain you want to delete or clear all formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you’ll need to know the code I.D., code length, and character match(es) your application requires. Use the Alphanumeric symbols (inside back cover) to read these options.
Note: You must hold the trigger while reading each bar code in a sequence.
To Add an Output Sequence
1.Scan the Enter Sequence symbol (see Require Output Sequence, page 3- 13).
2.Code I.D.
On the Symbology Charts on page
3.Length
Specify what length (up to 9999 characters) of data output will be acceptable for this symbology. Scan the four digit data length from the Programming Chart. (Note: 50 characters is entered as 0050. 9999 is a universal num- ber, indicating all lengths.) When calculating the length, you must count any programmed prefixes, suffixes, or formatted characters as part of the length (unless using 9999).
4.Character Match Sequences
On the ASCII Conversion Chart (Code Page 1252), page
5.End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or Save to save your entries.
Other Programming Selections
•Discard
This exits without saving any Output Sequence changes.
3 - 10