4 Initial Startup
Be sure to connect the system as shown in the wiring detail before powering up the unit. Apply power to the controller and all network devices. Then remove the SHDN jumper to start the unit.
ADatalogger (SDcard)
The DLC option for the controller collects data automatically and stores it on a digital flash Multi- MediaCard (SDcard). If the SDcard becomes full:
•The information logging is stopped
•No Sdcard flag is displayed on the screen
•The Sdcard LED blinks
Note: For log activation or deactivation, please refer to the Acquisition section.
Warning
BUser Interface
The main display indicates the firmware revision number, time and date, number of sensor/events/ groups programmed in the controller, etc.
LED Definition:Warn, Alarm and High Alarm — Red LEDs indicate that one or more sensors have reached the corresponding alarm level. If LED Warn is blinking, an Event is activated (no alarm).
Power: Green LED indicates that the controller is powered on and functioning properly.
Fault: Yellow LED indicates a fault (communication problem with a network device).
TX: Yellow LED will blink when the controller is sending information on the communication channel.
RX: Green LED will blink when a sensor sends
| Always deactivate datalogging function before | information to the controller. | |
| removing the SDcard. Never remove the SDcard | ||
| ||
| when the red LED is on. |
|
Figure 8. Datalogger
SD card
LED1
Card in use
Figure 9. User Interface
|
|
| Manning AirAlert 96d |
|
|
|
| Warn |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| Alarm |
|
|
|
|
|
|
|
| |
Keypad |
|
|
|
|
|
|
| High Alarm |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
The keypad is used to move |
|
|
|
|
| Power | ||
the cursor into the various |
|
|
|
|
|
| ||
|
|
|
|
|
| |||
programming fields (up, down, | Enter | ESC | Silence |
| Fault | |||
left and right) or to adjust |
|
|
|
|
| TX | ||
|
|
|
|
| ||||
|
|
|
|
| ||||
the display contrast. |
|
|
|
|
| RX | ||
Enter key |
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
| |||
|
|
|
|
|
|
| ||
The enter key is used to access |
|
|
|
|
|
| ||
the programming menu [which | ESC key |
|
|
|
|
| ||
| Silence key |
| ||||||
requires a password (default |
|
| ||||||
The escape key is used to |
| Will turn off the buzzer | ||||||
password is 9935)] and to modify |
| |||||||
exit the programming menu |
| of AirAlert 96d | ||||||
the programming fields. |
| |||||||
or to cancel an input. |
| (see latching option). | ||||||
|
|
|
| |||||
Manning | 9 |