Honeywell 99EXL0X-XXXXXXXI, 99EXLGX-XXXXXXXI, 99EXLWX-XXXXXXXI Remove Programs, Remove Programs, Resetting the Terminal, IPSM\Honeywell\Autoinstall, 2.Tap Remove. The following message appears:

The terminal is loaded with a number of pre-programmed regional settings. Select one from the list and the results appear on the screen. To see specific settings or to change a specific setting, tap on one of the tabs, make the change, and tap OK to save it.

Remove Programs

Remove Programs enables you to remove programs installed on the terminal. Any program (usually CAB or DLL files) stored in the \\IPSM\Honeywell\Autoinstall folder re-installs after a software upgrade or a factory reset. If a program is manually removed using the Remove Programs application, the program does not re-install on a hard or soft reset.

Note: A program (file) does not automatically install if it is added to the \\IPSM\Honeywell\Autoinstall folder and a hard or soft reset is performed. For information on program installation, see Installing Additional Software on page 8-10.

For information about the system resets, see Resetting the Terminal on page 2-13.See Honeywell support for more information on how to perform a factory reset.

1.Tap Remove Programs. In the list, select the program you want to remove.2.Tap Remove. The following message appears:3.Tap Yes. Wait while the program is removed.4.Verify that the program no longer appears in the list.

7 - 17