Honeywell 99EXL0X-XXXXXXXI, 99EXLGX-XXXXXXXI, 99EXLWX-XXXXXXXI Step, Step, Step, Step, Step, Step, Press the Power key, Press the Power key, Remove the battery door, then remove the battery, 3.Remove the battery door

Installing a SIM Card

!Carefully read all the information under Equipment Intended for Use in Potentially Explosive Atmospheres on page 2-1before you attempt to install a card.

1.Press the Power key to put the terminal in Suspend Mode.

2.Release the hand strap near the speaker on the back panel of the terminal.

3.Remove the battery door.

4.Wait at least 3 seconds, then remove the battery.5.Remove the T6 TORX screw securing the protective door closed.6.Lift up the lower left corner of the door to access the SIM card socket.

7.Unlock the access door to the memory socket by sliding the door toward the IrDA port side of the terminal.

8.Lift the door up to expose the socket.

9.Insert the SIM card into the socket.

Note: Make sure the interface on the card is connected to the SIM Card interface in the socket; align the beveled corner of the card with the beveled corner of the socket.

10.Close and lock the access door.

11.Close the protective door over the memory socket. Install and tighten the T6 TORX screw to secure the door closed.

12.Install the battery and the battery door, then reattach the hand strap.

13.Press the Power key or SCAN key to wake the terminal.

Step 5

Step 6

Step 7

Step 8

Step 9

Step 10

9 - 4