Securing the Base to the Wall Bracket

You can secure the base to the wall bracket by using the self tapping screws provided or you can use the optional DIN Rail.

To secure the base using the self tapping screws:

1.Position the base on the wall bracket, as shown.

2.Secure the base to the bracket using the four M3 x 9 mm self-tapping screws.

To secure the base using the optional DIN Rail:

Hardware Required

Wall Bracket

M3 x 9 mm Self-tapping Screws, Qty. 4

• DIN Rail, Qty. 1

•3/16 in. dia x 5/8 in. long pan head screw, Qty. 2

•1/2 in. OD x 7/32 in. ID x 3/64 in. thick washer, Qty. 2

•3/16 in. dia nut, Qty. 2

1.Position the DIN Rail on the wall bracket, as shown below.

2.Slide the screw through the slot on the DIN Rail and the mounting hole in the bracket.

3.Slide the washer onto the screw and tighten the nut to secure the assembly.

Wall Bracket, Qty. 1

Screw, Qty. 2

 

Washer, Qty. 1

DIN Rail, Qty. 1

 

Nut, Qty. 1

 

Washer, Qty. 1

Nut, Qty. 1

4.Remove the rubber feet on the bottom of the ChargeBase.

15 - 7