USER FUNCTIONS
Remote Phone Control Feature
Enter:
Your user code
(within eight seconds)
Upon entering remote phone control mode the Lynx will announce “System, enter code”.
Remote Phone Control Commands
To remotely disarm system:
Your user code
+ [1]
To remotely arm in AWAY mode:
Your user code
+ [2]
To remotely arm in STAY mode:
Your user code
+ [3]
To remotely arm in AWAY or STAY mode with no delay: | + [2] or [3] + [0] |
| Your user code |
To remotely activate X10 devices |
|
To remotely activate X10 devices 7 & 8: | + [#] + [4] + device no. |
Your user code |
|
To remotely deactivate X10 devices | |
To remotely deactivate X10 devices 7 & 8: | + [#] + [7] + device no. |
To remotely Bypass zones:
Your user code + [6] + zone no.
Your user code
To remotely activate Forced Bypass:
Your user code
+ [6] + [#]
To remotely check system status: [✻]
To end remote phone session: Hang Up or
Your user code
+ [9]
NOTES: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2)When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.
– 37 –
