USER FUNCTIONS
Scheduling User Interface
To access the Scheduling User Interface enter: |
|
|
|
|
|
|
| + |
|
|
|
|
Master user code or
Installer Code
FUNCTION
+[64]
The following entries will be sequentially prompted to the user. Note that all inputs are checked for validity upon entry and all invalid entries are rejected. Hitting a [*] will allow the entries to be accepted and advance to the next field. Hitting a [#] will reject the entry and back up one field. Hitting the [#] in the “Schedule Number” screen will exit the schedule programming.
NOTES: 1. During the schedule programming, if three minutes passes and no key was entered, the programming will be terminated and no values will be saved. Furthermore, if a zone is troubled while in schedule programming, the system will abort the programming mode and show the troubled zone, and any uncompleted program event will not be saved.
2.It is not possible to enter the schedule programming mode from a wireless keypad.
3.Pressing any key on a wireless (RF) keypad terminates Scheduling setup.
4.It is not possible to enter the schedule programming mode when either FC or CA is displayed on the display.
Because the keypad display does not show prompt titles, you must refer to these instructions while programming the system. The prompts are indicated by a number/letter combination.
The prompts for option #64 are as follows:
n
i d
:A b
b :
b d
:A E
E : 
Schedule | for selecting a schedule number |
Event | for selecting a schedule action |
Begin time (hrs, | for selecting a schedule begin time (hour, am/pm) |
| entry |
Begin time | for selecting a schedule begin time (minute) |
| entry |
Begin | for selecting a schedule begin day |
End time (hrs, | for selecting a schedule end time (hour, am/pm) |
| entry |
End time | for selecting a schedule end time (minute) |
| entry |
E d
End | for selecting a schedule end day |
d n
Device | for selecting a X10 device number |
– 31 –
