A S S E M B LY STEP 4
HARDWARE BAG 4 CONTENTS :
BOLT (F) | BOLT (D) | FLAT WASHER (E) |
25 mm | 15 mm | 8 mm |
Qty: 2 | Qty: 6 | Qty: 6 |
top view | top view |
|
| A. Open HARDWARE BAG 4 | ||
| B. With running deck in lowered position, | ||
|
| place console on upright masts. | |
| C. Secure console by partially inserting | ||
|
| 3 bolts (D) and 3 FLAT WASHERS | |
|
| (E) into side of left upright mast. | |
BOLT (F) |
| Remember to partially install | |
| these bolts. | ||
|
| ||
FLAT WASHER (E) | D. | Gently lift right side of the console | |
BOLT (D) | |||
| to connect the console cable. | ||
|
| ||
MAST |
| Carefully tuck wires in mast to avoid | |
|
| damage. Note: Do not pinch console | |
|
| cable. Be sure the console cable | |
* Be sure to tighten bolts after all are lined up. |
| prongs are aligned and the ends are | |
| tightly seated into each other. | ||
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
TREADMILL OPERATION
E. |
ASSEMBLED IN STEP |
F. |
G. |
Repeat step C above to assemble the right side upright mast and console.
Tighten all bolts completely.*
Once BOLTS (D) have been completely tightened, insert BOLTS
(F)into the back of the mast and completely tighten.
TROUBLESHOOTING CONDITIONING MAINTENANCE GUIDELINES
* Note: Be careful not to pinch any wires while assembling the masts.
&
11
LIMITED WARRANTY
