INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
P R E - A S S E M B LY
Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to lift the treadmill at this time. Remove plastic wrap from console masts.
note: During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware. Any grease, such as lithium bike grease is recommended.
A S S E M B LY STEP 1
HARDWARE BAG 1 CONTENTS :
BOLT (A) | FLAT WASHER (B) |
65 mm | 8 mm |
Qty: 4 | Qty: 4 |
LEAD WIRE | CONSOLE CABLE |
|
TREADMILL OPERATION
CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE
FLAT WASHER (B)
BOLT (A)
A
B Pull LEAD WIRE through RIGHT
CONSOLE MAST to drag upward.
C Place RIGHT CONSOLE MAST
into upright position using 2
BOLTS (A) and 2 WASHERS (B)
and tighten. Be sure to hold the console mast firmly, as it will not stay in the upright position on its own.
D Repeat on the left side. Note:
There is no wire in the LEFT
CONSOLE MAST.
LIMITED WARRANTY
