3)While maintaining a hold on the door, remove the hinge stop pin from hinge (B). Pull out the bottom of the door slightly, then gently remove the door from hinge (A). See Fig. 31.
4)Remove the 2 screws securing the top panel, then lift it off.
5)Remove all ice from the storage bin.
6)Remove the slope from the storage bin by carefully bending it in the center and releasing it from the 2 slope shafts.
7)Remove the scoop. Remove the 2 thumbscrews securing the scoop holder, then remove it.
8)Remove the screws securing the upper rear panel, then remove it.
9)Remove the clamp securing the drain plug, then lower the drain hose into a container. See Fig. 32. Remove the drain plug to drain the water from the reservoir and evaporator assembly.
10)After all of the water has drained, replace the drain plug in its correct position.
11)Remove the reservoir cover. Pour the cleaning solution into the reservoir until the solution starts to flow through the overflow hose. Replace the reservoir cover in its correct position.
Note: If there is excess scale on the extruding head, fill the reservoir as described above, then use a clamp on the reservoir hose between the reservoir and evaporator assembly to block flow. Remove the thumbscrews securing the spout, then remove the spout. Pour additional cleaning solution over the extruding head until the evaporator assembly is completely full.
Top Panel
Scoop
Holder
Slope
Hinge (B)
Hinge Stop Pin
Fig. 31
Hinge (A) | Spout | |
Packing | ||
|
Extruding
Head
Drain Plug
Clamp
Drain Hose
Reservoir 
Cover
Reservoir
Reservoir
Hose
Evaporator
Assembly
Overflow
Hose
Upper Rear Panel
Fig. 32
28
