ENGLISH
IMPORTANT
1.This booklet is an integral and essential part of the product and should be kept and preserved by the user. Please read carefully the guidelines and warnings contained herein as they are intended to provide the user with essential information for the continued safe use and maintenance of the product. In addition, it provides GUIDANCE ONLY to the user on the correct services and site location of the icemaker. Please preserve this booklet for any further consultation that may be necessary.
2.This is a commercial icemaker, and should be destined only to be used for the purpose for which it has been expressly designed and attached to a suitable storage bin as specified by Hoshizaki. Any other use should be considered improper and therefore dangerous. The manufacturer will not be held liable or responsible for any damage caused by improper, incorrect and unreasonable use.
I.Installation Instructions
WARNING
The installation must be carried out by qualified personnel, in accordance with current regulations, according to the manufacturer’s instructions.
1. Location
IMPORTANT
1.This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +7°C to +40°C. Normal operating water temperature should be within +7°C to +35°C. Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
2.The icemaker should not be located next to ovens, grills or other high heat producing equipment.
3.The location should provide a firm and level foundation for the equipment.
4.Allow 15 cm. clearance at rear, sides and
top for proper air circulation and ease of maintenance and/or service should they be required.
5.This appliance is not suitable for installation in an area where a water jet could be used and where dripping is not allowed.
6.Do not place anything in front of the louver.
7.This icemaker will not work at subfreezing temperatures. To prevent damage to the water supply line, drain the icemaker when air temperature is below zero.
2.Electrical Connection
WARNING
THIS APPLIANCE MUST BE EARTHED This icemaker requires an earth that meets the national and local electrical code requirements. To prevent possible severe electrical shock to individuals or extensive damage to equipment, install a proper earth wire to the icemaker. Turn off the power supply before any maintenance, repairs or cleaning is undertaken.
•This icemaker must have a separate power supply or receptacle of proper capacity. See the nameplate. It is recommended that this icemaker be the only electrical device on its power supply circuit.
•Stacked icemakers should each have a separate receptacle.
•Usually an electrical permit and services of a licensed electrician are required.
•If a power cord and/or a plug should need to be fitted/ replaced, it should only be done by a qualified service engineer.
•Factory fitted power cords are coloured in accordance with the following code:
Green & Yellow = Earth Blue = Neutral Brown = Live
(Plugs and power cords are not supplied with the
For the U.K. and the Republic of Ireland Only
•The
•The correct replacement for the detachable fuse cover is identifiable from the manufacturer’s reference number stamped on the plug.
•Supply of replacement fuse covers can be obtained from Hoshizaki Parts/Service Centres.
•Fuses should be rated at 13A and approved to BS 1362.
For KM-1301SAH-E only
A suitably sized power supply cord (see the rating on the nameplate) must be fitted by a qualified installer into the terminal box on the rear of the machine. The wires in the terminal box are coloured in accordance with the following code:
Green & Yellow = Earth Blue = Neutral Brown = Live
