Hotpoint osx 1036n dcx s, osx 1036s nd cx manual Troubleshooting, Sliding rack kit assembly

!Do not touch the light bulb directly with your hands.

GB

!Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

		A
Left	Right guide
guide rail	rail
B
	C
	of
		Direction
		extraction

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers A (see figure).

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

4.Finally, fit the frames on the spacers A.

!Do not place the sliding racks in position 5.

Troubleshooting

	Problem	Possible cause	Solution
	The “Clock button” and the	The appliance has just been	Set the clock.
	digits on the display flash.	connected to the electricity mains
		or there has been a blackout.
	A programmed cooking mode	There has been a blackout.	Reprogram the cooking mode.
	does not start.
	Only the high luminosity	The appliance is in standby mode	Press any button to exit
	“Clock button” is lit.		standby mode.
	An automatic mode has been	The temperature inside the oven	Wait for the oven to cool down.
	selected. “Hot” appears on the	is higher than the suggested
	display and cooking does not	value for the selected mode.
	start.
	Fan-assisted cooking has been	Positions 1 and 5: the direct	We recommend switching
	selected and the food looks burnt.	heat could cause	dripping pan positions halfway
		temperature-sensitive	through cooking.
		foods to burn.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
	18