CAUTION
CAUTION
1 Installing the HP LAN Card
Post-installation Procedure
Make sure that you have installed the HP LAN card before you perform the
Post-installation on a Windows 95 System
1Restart the PC. Windows 95 automatically detects, and installs the software for, the HP LAN card. You may be asked to insert one of the Windows 95 installation diskettes.
2Restart your PC when prompted to do so. Remember to remove the HP LAN Setup diskette before you do this.
The HP LAN card is now ready to use.
Post-installation on a Windows NT 4.0 System
1Restart the PC and start Windows. You do not need to
press 
+
+
to log on.
2When prompted to do so, insert the HP LAN Setup diskette into the diskette drive, and click OK. The setup wizard starts, and displays a dialog box indicating that the PC is ready to install the HP LAN card.
3Type the path to the NT master disk (C:\I386 if the operating system files were copied to the hard disk during the installation of Windows NT), then click Next. The installation of the HP LAN card starts automatically. When the installation is complete, the last page of the wizard is displayed.
4Click Finish to end the wizard.
5Restart your PC when prompted to do so. Remember to remove the HP LAN Setup diskette before you do this.
If a service pack was already installed on the PC before the HP LAN card was installed, the service pack must be
The HP LAN card is now ready to use.
10 English
18