LANVCP Error Codes

LANVCP error messages can be reported to either of the following two locations:

DThe user's terminal when the error occurs during an interactive session or a session spawned from an interactive session.

DThe system console when the error occurs during an unexpected session or session spawned from an unexpected session.

The error numbers are negative (to distinguish them from the positive, non"error trace message numbers).

-1: Class get return error <RTE error>

The RTE error occurred while attempting a class get; usually aborts VCPMT.

-2: Class write/read error <RTE error>

The RTE error occurred while attempting a class write, read, or write/read; usually aborts

VCPMT.

-3: Attempt to exceed maximum number of sessions

An attempt was made to start a new session and the memory space required would have exceeded the memory allocated for VCPMT. (Either let the node retry, or use a slower VCPMT which is able to handle more nodes.)

-4: Error in logging trace data, tracing disabled

Some error occurred in writing to the trace file or LU and tracing was automatically turned off. Tracing is not supported.

-5: IPL Table File access error

Some error occurred while attempting to look up the node_name, LAN address and LU, or download file name in the IPL table file (/FILES802/IPL_TABLE.TXT).

-11: VCPMT aborted due to excess RTE errors

VCPMT had too many RTE errors and aborted. See errors -1 and -2, above.

-12: Detected error in opening trace file

VCPMT was unable to open the trace file when an attempt was made to initiate tracing. Tracing is not supported.

-13: Detected LAN interface error <error number>

VCPMT received a bad LAN driver status from a request to the LAN card.

Error Codes & Descriptions A%3