Computer Setup

Select

To do this

 

 

Device Configurations

■ Enable/disable USB legacy support (enabled by default). When enabled,

 

USB legacy support allows the following:

 

Use of a USB keyboard in Computer Setup even when a Windows®

 

operating system is not running.

 

Startup from bootable USB devices, including a hard drive, diskette

 

drive, or optical drive connected by a USB port to the computer.

 

■ Select a parallel port mode: ECP (Enhanced Capabilities Port), standard,

 

bidirectional, or EPP (Enhanced Parallel Port).

 

■ Enable/disable fan always on while connected to an AC outlet (enabled

 

by default).

 

■ Enable/disable LAN Power Save (select models only). When enabled, saves

 

power by turning off the LAN when not in use (enabled by default).

 

■ Enable/disable Data Execution Prevention. When enabled, the processor can

 

disable some virus code execution, which helps to improve computer security.

 

■ SATA (Serial Advanced Technology Attachment) device mode. The following

 

options are available:

 

AHCI (Advanced Host Controller Interface)

 

IDE (Integrated Drive Electronics)

 

RAID (select models only)

Availability of the options above varies by computer model.

Enable/disable secondary battery fast charge (enabled by default).

Enable/disable HP QuickLook 2 (enabled by default).

Enable/disable Virtualization Technology (select models only; disabled by default).

Enable/disable TXT (Intel® Trusted Execution Technology) (select models only; disabled by default).

Enable/disable Dual Core CPU (select models only; enabled by default).

Enable/Disable Unified Extensible Firmware Interface (UEFI) mode (disabled by default).

Built-In Device Options

■ Enable/disable the wireless switch (enabled by default).

 

■ Enable/disable embedded WWAN device radio (select models only; enabled

 

by default).

 

■ Enable/disable embedded Bluetooth device radio (enabled by default).

 

■ Enable/disable the Network Interface Controller (LAN) (enabled by default).

 

■ Set the wake on LAN state. Options include the following:

 

Disabled

 

Boot to Network (set by default)

 

Follow Boot Order

 

■ Enable/disable the fingerprint device (enabled by default).

 

■ Enable/disable a modem device (enabled by default).

 

■ Enable/disable the embedded WLAN device (enabled by default).

 

■ Enable/disable LAN/WLAN switching (disabled by default).

 

■ Enable the ambient light sensor (enabled by default).

 

■ Enable/disable the Notebook Multibay device (enabled by default).

 

■ Enable/disable the integrated camera (select models only; enabled

 

by default).

 

 

 

(Continued)

5–6

Maintenance and Service Guide

Page 78
Image 78
HP 2730p 2730p manual Options are available