Problem | Possible cause | Solution | |
|
|
| |
| The NiMH batteries | You must recharge all four NiMH | |
| you are using were | batteries after fully draining them four | |
| recharged | times for the batteries to reach their | |
| incorrectly. | optimum capacity and performance. | |
|
|
| |
The wrong | The batteries were | Replace the batteries and then reset the | |
date and/or | dead or were | date and time using the camera menus. | |
time is | removed from the | To avoid losing date and time | |
shown. | camera for more | information, replace low batteries | |
| than 10 minutes. | promptly. | |
|
|
| |
The incorrect | The wrong language | Change the camera language by using | |
language is | was selected when | the camera’s Setup menu. | |
set on the | you started the |
| |
camera. | camera the first |
| |
| time. |
| |
|
|
| |
A long delay | The camera is still | Wait a few seconds for the camera to | |
occurs after I | saving the last | finish processing the image, and then | |
press the | picture you took. | press the SHUTTER button halfway down. | |
shutterbutton |
| When a steady green light appears next | |
before the |
| to the viewfinder, the camera is ready to | |
camera takes |
| take another picture. | |
a picture. |
|
| |
The flash is | Wait until the flash icon on the status | ||
| |||
| recharging. | LCD stops blinking before taking | |
|
| another flash picture. | |
|
|
| |
| The light is low and | In dim light the camera requires a longer | |
| the flash is turned | exposure. Either hold the camera very | |
| off. | steady until it takes the picture; or | |
|
| improve the lighting conditions or use | |
|
| the flash. |
A red light | Space in memory is |
appears next | insufficient for the |
to the | picture. (The status |
viewfinder | LCD shows “0” |
when I press | images remaining.) |
the shutter |
|
button. |
|
Make room in memory by deleting or unloading images, or select a lower image quality setting.
If you do not have a CF memory card installed, installing one will give you room for more images. If you have a CF memory card, remove it and see if you have room in internal memory (the status LCD shows a number other than 0), or install a new CF memory card. For more information, see “Installing a CF memory card” on page 40.
Troubleshooting | 53 |