Verify Jetdirect Print Server Operation

1.Print a Jetdirect Configuration page and check for status messages.

In most HP LaserJet printers, a Jetdirect Configuration page will automatically print when you print a Printer Configuration page.

In HP DesignJet printers, Jetdirect configuration information will be included on the Service Configuration print.

2.In the first section of the Jetdirect Configuration Page, look for the status message “I/O CARD READY”. See Figure 2-2.

This section of the configuration page also contains product- specific information, such as:

■HP Jetdirect product number

■Firmware revision number

■LAN Hardware (MAC) address

■Manufacturing identification number

Note

For a description of other messages that may appear

 

on the Jetdirect Configuration Page, refer to the

 

applicable HP Jetdirect Administrator’s Guide

 

located on the HP Jetdirect CD-ROM.

3.If I/O CARD READY appears, the card has been installed successfully. Proceed to If Required, Configure Jetdirect With Your Network Settings.

If I/O CARD READY does not appear, check that you have:

■Installed the print server correctly and properly connected the print server to the network

■Verified that the network is operating properly

You can turn the printer off and then on again to reinitialize the print server and try again.

ENWW

Installation Procedures 12