Remove Power to Printer, Install the Hardware, RJ-45 | HP 615N

Remove Power to Printer, Install the Hardware

Figure 2-1 Remove Power, Install and Connect the Card

RJ-45

1.Turn off the printer and remove the printer’s power cord.

2.Identify an available HP Enhanced I/O (EIO) slot (typically, in the back of the printer).

Note	For printers with multiple EIO slots, you can install
	the print server into any EIO slot in the HP printer.

3.If the slot has a cover plate, remove it.

4.Insert the print server card. Align the card with the guide rails in the slot.

5.Press the card into the slot until firmly seated and tighten each retaining screw a little at a time until both screws are secure.

6.Connect the network cable to the card using the RJ-45 connector port.

7.Turn on the printer.

ENWW	Installation Procedures 11

Image 11

HP 615N manual Remove Power to Printer, Install the Hardware, RJ-45

Contents

Hp jetdirect Setup Guide HP Jetdirect Print Servers Models 620n/615n EIO Applicable Products Table of Contents HP Jetdirect EIO Control Panel Menus HP Jetdirect Solutions SummarySpecifications and Regulatory Statements Warranty Service HP Support and Service HP Jetdirect EIO Print Server Introduction Typical HP Jetdirect Print Server Installation What You Need For Help Installation Procedures Verify Printer Operation RJ-45 Remove Power to Printer, Install the Hardware Verify Jetdirect Print Server Operation Applicable HP Jetdirect Administrator’s Guide See in this guide for link configuration Configuration Tools If Required, Configure Jetdirect With Your Network Settings Menus Add the Printer to Your Network Server or System Adding a Printer to Your System Configuration Microsoft or Novell NetWare Networks Client-Server Networks Apple Mac OS Networks Unix Networks To View Documents on the CD-ROM For other supported operating systems, you can 10/100Base-TX Link Configuration Troubleshooting Tools HP Jetdirect Configuration LED State Description Link TroubleshootingLink-Speed LEDs Parameter Expected Messages for 10/100TX Cards On Autonegotiation is enabled, orOFF Autonegotiation is disabled, 10/100TX Configuration has been manually set Controlling Network Protocols Resetting to Factory Defaults Enabling or Disabling Network Protocols Client-Server printing Peer-to-Peer printing Network Addresses Network Protocols Table A-1 Using HP Jetdirect CD-ROM Software Network System Setting Up Your Network Printer HP-UX IPXUnix networks HP Jetdirect Printing Support HP Jetdirect Solutions Summary Tools Overview DLC/LLC Supported Network ProtocolsTCP/IP IPX/SPX HP Jetdirect Printer Installer for Unix HP Installation Software HP Internet Printer Connection HP LaserJet Utility for Mac OS Table B-3. HP Software Solutions 3 HP IP/IPX Printer Gateway HP Jetdirect EIO Control Panel Menus Introduction Classic Control Panel CFG TCP/IP= Https CFG IPX/SPX=CFG LINK= WEB= Host Name TCP/IP EnableGraphical Control Panel Dhcp Renew ConfigMethod Dhcp Release Manual SettingsDefault IP IPX/SPX Enable Frame Type Atalk EnableDLC/LLC Enable Reset Speed Link Environmental Specifications and Regulatory StatementsHP Jetdirect EIO Internal Print Server Electrical J7934A 620n J6057A 615n Regulatory StatementsElectromagnetic FCC Statements European Community Declaration of Conformity HP Jetdirect Print Servers RRL Statement Korea AustraliaCanada Vcci Japan Taiwan Class a Chinese Safety Statement HP Product Duration of Limited Warranty Warranty Service Your Authorized Dealer Firmware Upgrades HP Support and Service HP Support Online Table F-1 Support Telephone Numbers 1 HP Support By Phone USA Table F-1 Support Telephone Numbers 2Denmark + 45 39 29 Portugal +351 21 Finland SAR Hewlett-Packard Development Company, L.P