Installing the Switch

Installing the Switch

Installation Procedures

5. Connect the Switch to a Power Source

1.Plug the included power cord into the switch’s power connector and into a nearby AC power source.

2.Re-check the LEDs during self test. See “LED Behavior” on page 2-7.

Securing the power cord

1.Connect the power cord to the power supply.

2.Make a small loop in the power cord, approximately 3 to 4 inches and insert the velcro strap through the loop and through the handle on power supply.

3.Insert the end of the velcro strap through the slot in the other end of the velcro strap.

4.Tighten the velcro strap around the loop in the power cord.

5.Wrap the excess velcro strap around the power cord loop and through the power supply handle a couple of times and secure the velcro strap to itself.

1.2.

2-14