Installing the Switch
Installing the Switch
Installation Procedures
1.Connect the power cord supplied with the switch to the power connector on the back of the power supply, and then into a properly grounded electrical outlet.
| Figure |
|
|
| N o t e | The Series 6600 Switches do not have a power switch. They are powered on |
| when the power cord is connected to the power supply and to a power source. |
| For safety, the power outlet should be located near the switch installation. |
| The power supply cannot be removed when the power cord is connected. |
| The switch automatically adjusts to any voltage between |
| volts and either 50 or 60 Hz. No voltage range settings are required. |
| If your installation requires a different power cord than the one supplied with |
| the switch, be sure to use a power cord displaying the mark of the safety |
| agency that defines the regulations for power cords in your country. The mark |
| is your assurance that the power cord can be used safely with the switch. |
| 2. Check the LEDs on the switch as described below. When the switch is |
| |
| powered on, it performs its diagnostic self test. Self test takes approxi- |
| mately 50 seconds to complete. |