Table
Number | Controls/lndicators | Description | Page |
|
|
|
|
7 | Output Control Keys | OUTPUT SELECT - Selects one of the output channels | 36, 37, |
| (These twelve keys are | for local control or display. This key allows the channels | 83, 83 |
| output dependent). | to be selected in forward (ç) or reverse (è) sequence. |
|
|
| VSET - Displays the selected output's present voltage | 37, 62, |
|
| setting. The setting can be changed using the numeric | 63, 83 |
|
| entry keys. |
|
|
| ISET - Displays the selected output's present current | 37, 62, |
|
| setting. The setting can be changed using the numeric | 63, 83 |
|
| entry keys. |
|
|
| OUTPUT ON/OFF - Toggles the selected output on and | 63, 83 |
|
| off. When off, "DISABLED" appears on the display. |
|
|
| OVSET - Displays the selected output's overvoltage trip | 37, 63, |
|
| point. The setting can be changed using the numeric entry | 83 |
|
| keys. |
|
|
| OVRST - Resets the selected output's overvoltage | 37, 63, |
|
| crowbar (the cause of the overvoltage must be removed | 83 |
|
| before reset is successful). |
|
|
| OCP - Toggles the selected output's overcurrent | 37, 63, |
|
| protection circuit on and off. | 83 |
|
| OCRST - Resets the selected output's overcurrent | 37, 63, |
|
| condition and returns the output to its previous settings | 83 |
|
| (the cause of the overcurrent must be removed before reset |
|
|
| is successful). |
|
|
| METER - Returns the display to the metering mode from | 83 |
|
| any other mode (e.g. VSET). In the metering mode, the |
|
|
| measured output voltage and current of the selected output |
|
|
| are displayed. |
|
|
| DLY - Displays the reprogramming delay for the | 69, 83 |
|
| specified channel. The setting can be changed using the |
|
|
| numeric entry keys. |
|
|
| UNMASK - Displays the present setting of the mask | 63, 83 |
|
| register for the specified channel. The setting can be |
|
|
| changed using the numeric entry keys. |
|
|
| FAULT - Displays the contents of the fault register for | 68, 68, |
|
| 83 | |
|
| the specified channel. A bit gets set in the fault register | |
|
| when the corresponding bit is set in both the status and |
|
|
| mask registers. Pressing the FAULT key also clears the |
|
|
| fault register. |
|
|
|
|
|
34 Getting Started