|
| Table |
Error Code | Message | Explanation |
(ERR? query) | (ERR key) |
|
|
|
|
0 | NO ERROR | Indicates there are no errors. |
1 | INVALID CHAR | You sent the supply a character it did not recognize. |
2 | INVALID NUM | The format of your number is incorrect. Check syntax (see Chapter 5). |
3 or 28 | INVALID STR | You sent a command the supply does not understand. Resend a recognizable |
|
| command. |
4 | SYNTAX ERROR | You sent a command with improper syntax. Check syntax of your command |
|
| (see Chapter 5). |
5 | NUMBER RANGE | An out of range number was sent. Send a new number within the legal range. |
6 | NO QUERY | The computer addressed the supply to talk, but it did not first request data. Send |
|
| query first and then address the supply to talk. |
7 | DISP LENGTH | Quoted string in the DSP command exceeds the display length of 12 characters. |
8 | BUFFER FULL | May occur if too many numbers are sent. Error code 4 or error code 5 are more |
|
| likely to occur for this condition. |
9 | EEPROM ERROR | The EEPROM on the |
|
| commands. An instrument failure has occurred and service is required. Refer to |
|
| the Troubleshooting Section in the Service Manual. |
10 | HARDWARE ERR | An output error has occurred on an unknown output. Service is required. Refer |
|
| to the Troubleshooting Section in the Service Manual. |
11HDW ERR CH 1 Error codes 11 through 14 refer to a specific output where an output error has occurred. Service is required. Refer to the Output Board Troubleshooting section in the Service Manual.
12 | HDW ERR CH 2 | Same as in error 11. |
13 | HDW ERR CH 3 | Same as in error 11. |
14 | HDW ERR CH 4 | Same as in error 11. |
15 | NO MODEL NUM | The supply's model number cannot be found. The |
|
| defective or the supply may require reprogramming. Refer to the |
|
| Troubleshooting section of the Service Manual. |
16 | CAL ERROR | An error has occurred during calibration. This may be the result of out of range |
|
| numbers sent. If recalibration (See Appendix A) does not fix this there may be a |
|
| hardware failure (Refer to the Troubleshooting Section in the Service Manual). |
110 Error Codes and Messages