User’s Manual
2.2 Installation Procedure
This chapter explains you the instructions of how to setup your system.
1.Turn off the power supply.
2.Insert the DIMM module (be careful with the orientation).
3.Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for flat panel. A CRT monitor must be connected in order to change CMOS settings to support flat panel.
4.Connect power supply to the board via the ATXPWR.
5.Turn on the power.
6.Enter the BIOS setup by pressing the delete key during boot up. Use the “LOAD BIOS DEFAULTS” feature. The Integrated Peripheral Setup and the Standard CMOS Setup Window must be entered and configured correctly to match the particular system configuration.
7.If TFT panel display is to be utilized, make sure the panel voltage is correctly set before connecting the display cable and turning on the power.