3.5.2.4 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected in these items.
| Item |
|
| Description |
|
|
|
|
| ||
| Floppy |
|
| Floppy Device |
|
| LS120 | LS120 Device | |||
| Hard Disk Device 0~1 | ||||
| SCSI |
| SCSI Device | ||
| CDROM |
| CDROM Device | ||
| ZIP100 |
| |||
| USB Floppy Device | ||||
| USB ZIP Device | ||||
|
| USB CDROM Device | |||
|
| USB Hard Disk | |||
| LAN |
| Network Device | ||
| Disabled | Disabled any boot device | |||
3.5.2.5 Swap Floppy Drive
While system has two floppy drivers installed, this item will be affected. This function is to assign physical drive B to logical drive A.
Item | Description |
Enabled | Assign physical drive B to logical drive A |
Disabled | No change |
3.5.2.6Boot Up NumLock Status Select power on state for NumLock.
Item | Description |
On | Enable NumLock |
Off | Disable NumLock |
3.5.2.7 Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
Item | Description |
Normal | A pin in the keyboard controller controls Gate A20 |
|
|
Fast | Lets chipset control Gate A20 |
3.5.2.8 Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When enabled, the typematic rate and typematic delay can be selected.
Item | Description |
Enabled | Enable typematic rate/delay setting |
Disabled | Disable typematic rate/delay setting |
3.5.2.9 Typematic Rate <Chars/Sec>
Sets the number of times a second to repeat a key stroke when you hold the key down The choices: 6, 8, 10, 12, 15, 20, 24, 30.
72