HP C309a Case B Set up the HP Photosmart with DSL, To set up the product with a separate fax line

To set up the product with a separate fax line

1.Using the phone cord supplied in the box with the product, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the product.

NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the product, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office.

2.Change the Auto Answer setting to the lowest number of rings to wait before answering (two rings).

3.Run a fax test.

When the phone rings, the product will answer automatically after the number of rings you set in the Auto Answer setting. Then it will begin emitting fax reception tones to the sending fax machine and receive the fax.

Case B: Set up the HP Photosmart with DSL

If you have a DSL service through your telephone company, use the instructions in this section to connect a DSL filter between the telephone wall jack and the HP Photosmart. The DSL filter removes the digital signal that can interfere with the HP Photosmart, so the HP Photosmart can communicate properly with the phone line. (DSL might be called ADSL in your country/region.)

NOTE: If you have a DSL line, ensure that the DSL Filter is connected. Otherwise, you will not be able to send and receive faxes with the HP Photosmart.

Figure 2-2 Back view of the HP Photosmart

Fax setup

1Telephone wall jack

2DSL filter and cord supplied by your DSL provider

3Use the phone cord supplied in the box with the HP Photosmart to connect to the "1-LINE" port

Set up the HP Photosmart for faxing 19