2.Loosen the 2 Phillips PM2.5×5.0 captive screws (1) that secure the
3.Lift the cover off the computer (2). The
4.Disconnect the two WLAN antenna cables (1) from the WLAN module.
5.Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the computer. (The edge of the module opposite the slot rises away from the computer.)
6.Remove the WLAN module (3) by pulling it away from the slot at an angle.
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module authorized for use in the computer by the governmental agency that regulates wireless devices in your country or region. If you replace the module and then receive a warning message, remove the module to restore computer functionality, and then contact technical support through Help and Support.
NOTE: WLAN modules are designed with a notch (4) to prevent incorrect insertion into the WLAN module slot.
Reverse this procedure to install a WLAN module.
ENWW | Component replacement procedures 59 |
