11.Tilt the left side of the diskette drive down slightly (1) so that the top lips of the guide screws are not caught behind the metal frame, then pull the drive out of the drive bay (2).

Figure 2-33Removing the Diskette Drive

12.Disconnect the power cable (1) and data cable (2) from the back of the hard drive.

Figure 2-34Disconnecting the Hard Drive Power Cable and Data Cable

CAUTION Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A sharp bend can break the internal wires.

ENWW

Installing and Removing Drives 39