2
Setup Utilities and Diagnostics Features
Setup Utilities (F10) and diagnostic features provide information needed about the computer system when contacting Customer Support. These tools can also be used to:
■Change factory default settings and to set or change the system configuration, which may be necessary when you add or remove hardware.
■Determine if all of the devices installed on the computer are recognized by the system and functioning properly.
■Determine information about the operating environment of the computer.
■Solve system configuration errors detected but not automatically fixed during the
■Establish and manage passwords and other security features.
■Establish and manage
✎All features identified in this chapter may not be available on all HP products.
2.1POST is a series of diagnostic tests that runs automatically when the system is turned on. POST checks the following items to ensure that the computer system is functioning properly:
■Keyboard
■Memory modules
■Diskette drives
■All IDE (ATA) mass storage devices
■Processors
■Controllers
✎If the Supervisor Password is set, a prompt appears on the screen while POST is running. You will need to enter the password before continuing. Refer to Chapter 3, Section 3.1, “Initial Configuration and Deployment,” for information on setting, deleting, or bypassing the password.
If POST finds an error in the system, an audible and/or visual message occurs. For POST error messages and their solutions refer to Appendix C, “POST Error Messages.”
Service Reference Guide, dx2200 MT |