Desktop Management
2.As soon as the computer is turned on, press the F10 key to enter Computer Setup.
✎If you do not press the F10 key at the appropriate time, you must turn the computer off, then on again, and press the F10 key again to access the utility.
If you are using a PS/2 keyboard, you may see a Keyboard Error
3.Select Set User Password and follow the instructions on the screen.
4.Before exiting, click Save and Exit Setup.
Entering a User Password
To enter a user password, complete the following steps:
1.Turn on or restart the computer. If you are in Windows, click Start > Shut Down > Restart.
2.When the prompt appears on the monitor, type your current password, then press Enter.
✎Type carefully; for security reasons, the characters you type do not appear on the screen. If you enter the password incorrectly, inclining beeping tones are heard. Try again.
Entering a Supervisor Password
If a supervisor password has been established on the computer, you will be prompted to enter it each time you run Computer Setup.
1.Turn on or restart the computer. If you are in Windows, click Start > Shut Down > Restart.
2.As soon as the computer is turned on, press the F10 key to enter Computer Setup.
✎If you do not press the F10 key at the appropriate time, you must turn the computer off, then on again, and press the F10 key again to access the utility.
If you are using a PS/2 keyboard, you may see a Keyboard Error
3.When the prompt appears on the monitor, type the supervisor password, then press the Enter key.
✎Type carefully; for security reasons, the characters you type do not appear on the screen. If you enter the password incorrectly, inclining beeping tones are heard. Try again.
Changing a User or Supervisor Password
1.Turn on or restart the computer. If you are in Windows, click Start > Shut Down > Restart.
2.To change the user password, go to step 3.
To change the supervisor password, as soon as the computer is turned on, press the F10 key to enter Computer Setup.
Service Reference Guide, dx2200 MT |