HP ep9010, ep9012 manual Replacing the battery in the remote control

Maintaining the projector

5.Insert the new lamp module into the projector and tighten the two screws.

6.Insert the tab on the front cover into the slot in the projector and close the cover.

7.Tighten the screws that hold the cover.

8.Turn on the projector. If the lamp does not turn on after the warm-up period, try reinstalling the lamp.

9.Press menu, go to Setup > Reset lamp hours, and press ok.

Replacing the battery in the remote control

1.On the back of the remote control, push in the tab 1 and remove the battery cover 2 to reveal the batteries.

2.Remove the old batteries and install two new AAA batteries 3.

3.Install the battery cover.

When discarding old batteries, contact your local waste-disposal provider regarding local restrictions on the disposal or recycling of batteries.

User’s Guide 53