Connecting the Power and Video Cables | HP FX75 manual

Connecting the Power and Video Cables

Before connecting any cables, make sure that the computer and display are turned off.

To connect the power and video signal cables:

1Locate the A/C power adapter with attached power cable.

6HP Pavilion FX75 Flat Panel Display User’s Guide

2Connect the power cable to the power jack on the back of the display.

Power jack

Analog Video Input port

Digital Video Input port

Filename: fx75UGrw.doc	Title: Book Title
Template: HP-Print.dot	Author: WASSER, Inc. Last Saved By: WASSER, Inc.

Revision #: 30 Page: 6 of 43 Printed: 10/16/00 03:31 PM

Image 10

HP FX75 manual Connecting the Power and Video Cables

Contents

HP Pavilion FX75 Flat Panel Display User’s Guide Revision # 30 Page 2 of 43 Printed 10/16/00 0331 PM Contents Iv HP Pavilion FX75 Flat Panel Display User’s Guide Introduction Introduction Do not cover the air vents For Your SafetyHP Pavilion FX75 Flat Panel Display User’s Guide Display has been dropped or the cabinet has been damaged Installation Unpacking the Display InstallationPositioning the Display Connecting the Power and Video Cables Plug the two-prong power cord into a power Connecting Stereo Speaker System Cable plug On the audio cable. This connector is labeled subwooferDisplay. The jack is colored blue to match Is located Using the Display Power button Turning the Display On and Off Using Screen Savers Tilting the Display Setting the Video Mode Since the inherent format of the FX75 display is Setting the Refresh Rate Caring For Cleaning the Display Minimizing Energy Use Cleaning the Screen Changing Display Settings Changing Display Settings Using the Control Buttons Displaying the OSD Window New mode Option Description Selecting Options OSD Window Using Auto Setup Press the Select button to execute your selection Adjusting the Image Press the Select button again to choose Auto Setup Positioning the Image Table below briefly describes each of these functions Selecting a Scaling Mode Scaling options are Adjusting the Sharpness Level Adjusting Color Settings Adjusting Gamma Correction Adjusting Color Temperature See Saving and Restoring Color Settings onTo adjust color temperature Adjusting RGB or Black Level Saving and Restoring Color Settings Adjusting Advanced Settings Adjusting the Phase and Clock Selecting the Video Interface To select the video interface Troubleshooting Message Check Cable appears on my display Message Unknown Mode Detected appears on my display Troubleshooting Technical Information FX75 Display Information FX75 Video Modes Unknown Video Modes Regulatory Information Declaration of Conformity FCC Statement Regulatory Information General Notice Revision # 30 Page 39 of 43 Printed 10/16/00 0331 PM