For Your Safety, Do not cover the air vents | HP FX75 instruction

NA unique system for desktop cable management: a cable tunnel that goes under the base and a cable claw behind the display

NFlicker-free performance across all recommended video modes

NSupport for high refresh rates up to 85 Hz for analog video input

NPremium color performance using PerfectColor™ technology

NState-of-the-art IQSync™ technology that synchronizes the display to any known video mode

NA power-saving feature that is compatible with Microsoft® Windows

NCompliance with Swedish MPR II guidelines for reduced electromagnetic emissions

2HP Pavilion FX75 Flat Panel Display User’s Guide

For Your Safety

For your safety and the protection of your display, follow these precautions:

NUse only the factory-supplied power cord.

Warning: To completely disconnect power from the display, you must remove the power cable from the power socket and the display.

NTo prevent electrical shock, do not disassemble the display. The cover should be removed only by qualified service personnel.

NDo not cover the air vents.

NTo avoid the risk of damage to the display and electrical shock to yourself, do not expose the display to rain or moisture.

Filename: fx75UGrw.doc	Title: Book Title
Template: HP-Print.dot	Author: WASSER, Inc. Last Saved By: WASSER, Inc.

Revision #: 30 Page: 2 of 43 Printed: 10/16/00 03:31 PM

Image 6

HP manual For Your Safety, Do not cover the air vents, HP Pavilion FX75 Flat Panel Display User’s Guide

Contents

HP Pavilion FX75 Flat Panel Display User’s Guide Revision # 30 Page 2 of 43 Printed 10/16/00 0331 PM Contents Iv HP Pavilion FX75 Flat Panel Display User’s Guide Introduction Introduction For Your Safety Do not cover the air ventsHP Pavilion FX75 Flat Panel Display User’s Guide Display has been dropped or the cabinet has been damaged Installation Installation Unpacking the DisplayPositioning the Display Connecting the Power and Video Cables Plug the two-prong power cord into a power Connecting Stereo Speaker System Cable plug On the audio cable. This connector is labeled subwooferDisplay. The jack is colored blue to match Is located Using the Display Power button Turning the Display On and Off Using Screen Savers Tilting the Display Setting the Video Mode Since the inherent format of the FX75 display is Setting the Refresh Rate Caring For Cleaning the Display Minimizing Energy Use Cleaning the Screen Changing Display Settings Changing Display Settings Using the Control Buttons Displaying the OSD Window New mode Option Description Selecting Options OSD Window Using Auto Setup Press the Select button to execute your selection Adjusting the Image Press the Select button again to choose Auto Setup Positioning the Image Table below briefly describes each of these functions Selecting a Scaling Mode Scaling options are Adjusting the Sharpness Level Adjusting Color Settings Adjusting Gamma Correction See Saving and Restoring Color Settings on Adjusting Color TemperatureTo adjust color temperature Adjusting RGB or Black Level Saving and Restoring Color Settings Adjusting Advanced Settings Adjusting the Phase and Clock Selecting the Video Interface To select the video interface Troubleshooting Message Check Cable appears on my display Message Unknown Mode Detected appears on my display Troubleshooting Technical Information FX75 Display Information FX75 Video Modes Unknown Video Modes Regulatory Information Declaration of Conformity FCC Statement Regulatory Information General Notice Revision # 30 Page 39 of 43 Printed 10/16/00 0331 PM