Chapter 6

To set the fax error-correction mode

1.Press Setup.

2.Press the right arrow to select Fax Settings, and then press OK.

3.Press the right arrow to select Error Correction, and then press OK.

4.Press the right arrow to select On or Off, and then press OK.

Set the dial type

Use this procedure to set tone-dialing or pulse-dialing mode. The factory-set default is Tone. Do not change the setting unless you know that your phone line cannot use tone dialing.

NOTE: The pulse-dialing option is not available in all countries/regions.

To set the dial type

1.Press Setup.

2.Press the right arrow to select Basic Settings, and then press OK.

3.Press the right arrow to select Tone or Pulse, and then press OK.

4.Press the right arrow to select the appropriate option, and then press OK.

Set the redial options

If the device was unable to send a fax because the receiving fax machine did not answer or was busy, the device attempts to redial based on the settings for the busy- redial and no-answer-redial options. Use the following procedure to turn the options on or off.

•Busy redial: If this option is turned on, the device redials automatically if it receives a busy signal. The factory-set default for this option is ON.

•No answer redial: If this option is turned on, the device redials automatically if the receiving fax machine does not answer. The factory-set default for this option is OFF.

To set the redial options

1.Press Setup.

2.Press the right arrow to select Fax Settings, and then press OK.

3.Press the right arrow to select Redial Options, and then press OK.

4.Press the right arrow to select the appropriate Busy Redial or No Answer Redial options, and then press OK.

Set the fax speed

You can set the fax speed used to communicate between your device and other fax machines when sending and receiving faxes. The default fax speed is Fast.

If you use one of the following, setting the fax speed to a slower speed might be required:

•An Internet phone service

•A PBX system

58 Fax