Bottom Margin, Default = Valid

Change to Invalid if you want the printer to ignore the bottom margin setting.

CAUTION!

Setting the Bottom Margin to Invalid can cause loss of data and damage the printhead by allowing printing without paper.

Busy Line, Default = SSD-

Appears only when the optional Serial Interface is installed. If Ready/ Busy protocol (factory default) is selected, you can choose which line your system monitors for a busy signal:

lSSD -9V, select SSD-

lSSD +9V, select SSD+

lDTR -9V, select DTR

lRTS -9V, select RTS Busy Time, Default = 200 ms

Appears only when the optional Serial Interface is installed. Sets the length of the busy signal when the Ready/Busy protocol (factory default) is engaged.

Busy Time Default = 200ms

Appears only when the optional Serial Interface is installed. Sets the length of the Busy signal when the Ready/Busy protocol (factory default) is enabled.

Centering Position, Default = DEFAULT

Used to limit printhead travel when printing narrow columns.

lSelect Mode 1 for the narrow carriage printer.

lSelect Mode 1 or Mode 2 for the wide carriage printer.

MENU MODE > 36