![](/images/new-backgrounds/1259910/259910135x1.webp)
d.Battery (see Battery on page 51)
e.System board (see System board on page 53) Remove the docking connector cable:
1.Disconnect the vibrator module cable (1) from the docking connector cable.
2.Disconnect the speaker cable (2) from the docking connector cable.
3.Remove the two Phillips PM1.3×2.0 screws (3) that secure the docking connector cable bracket to the bottom cover.
4.Remove the docking connector bracket (4).
The docking connector bracket is included in the Button Kit, spare part number
5.Detach the docking connector cable (1) from the surface of the bottom cover. (The docking connector cable is attached to the bottom cover with
6.Release the docking connector (2) from the bottom cover by sliding it away from the opening in the bottom edge.
60 | Chapter 5 Removal and replacement procedures |