3.Detach the cable connector board cable (2) from the front cover. (The cable connector board cable is attached to the front cover with
4.Remove the two Phillips PM1.3×3.0 screws (3) that secure the bar code scanner module to the front cover.
5.Remove the two Phillips PM1.9×3.0 screws (4) that secure the cable connector board to the front cover.
6.Remove the bar code scanner module (5) and the cable connector board and cable.
7.Turn the bar code scanner module and the cable connector board over so the ZIF connector on the back of the cable connector board is accessible.
74 | Chapter 5 Removal and replacement procedures |
