7.Remove the
Reverse this procedure to install the credit card reader boards.
Credit card reader
Description | Spare part number |
|
|
Credit card reader |
|
|
|
Before removing the credit card reader, follow these steps:
1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.Disconnect the power from the tablet by unplugging the power cord from the tablet or the Retail Jacket.
3.Disconnect all external devices from the Retail Jacket.
4.Remove the top cap (see Top cap on page 67).
5.If installed, remove the tablet from the Retail Jacket (see Top cap on page 67).
6.Remove the front cover (see Front cover on page 69).
Remove the credit card reader:
1.Disconnect the credit card reader cable (1) from the
2.Release the credit card reader cable (2) from the routing channel built into the rear cover.
3.Remove the two Phillips PM1.9×3.0 screws (3) that secure the retention tabs and the credit card reader to the rear cover.
4.Remove the two retention tabs (4).
80 | Chapter 5 Removal and replacement procedures |
