CHAPTER 8 BIP INTERNET PRINTING INSTALLATION

Brother Internet Print

Using TELNET to Configure the Print / Fax server

Skip this section if you used BRAdmin or a Web Browser to configure the remote Print / Fax server.

As an alternative to BRAdmin, you can use the Print / Fax server remote console to configure the Print / Fax server. The console can be accessed via TELNET. When you access the Print / Fax server using these utilities, you will be asked for a password. The default password is "access".

1.When you get the "Local>" prompt after connecting to the console, enter the command:

SET POP3 ADDRESS ipaddress

where ipaddress is the IP address of your POP3 server (consult with your network administrator if you do not know this address).

2.Enter the command:

SET POP3 NAME mailboxname

SET POP3 PASSWORD emailpassword

where mailboxname is the name of the remote Print / Fax server mailbox and emailpassword is the password associated with this mailbox. Usually the mailbox name is the same as the first part of the E-mail address that you defined previously (for example, usually if the E-mail address is emailprinter@xyz.com, then the mailbox name is emailprinter).

3.The Print / Fax server is set by default to poll the POP3 server every 10 minutes. If you wish to change this value, enter the command:

SET POP3 POLLING rate where rate is the polling rate in minutes.

Type EXIT to exit the console and save the changes. You have now completed configuring the Print / Fax server.

8-6