To calibrate the linefeed

Control panel: Press theSetup button, select Tools, select Calibrate Linefeed, and then press OK.

Embedded Web server: Click the Settings tab, click Device Services in the left pane, select Calibrate Linefeed from the drop-down list in the Print Quality section, and then click Run Diagnostic.

Toolbox (Windows): Click the Services tab, and then click Calibrate Linefeed and follow the onscreen instructions.

HP Printer Utility (Mac OS): Click Calibrate Linefeed from the Information and Support panel.

To clean the printheads

NOTE: Cleaning uses ink, so clean the printheads only when necessary.

The cleaning process takes up to 3.5 minutes. Some noise might be generated in the process.

Control panel: Press the Setup button, select Tools, and then select Clean Printhead.

Embedded Web server: Click the Device Settings tab, click Device Services in the left pane, select Clean printheads from the drop-down list in the Print Quality section, and then click Run Diagnostic.

Toolbox (Windows): Click the Services tab, and then click Clean Printheads and follow the onscreen instructions.

HP Printer Utility (Mac OS): Click Clean from the Information and Support panel.

To clean the printhead contacts manually

After the printheads are installed, you might get a control panel message telling you the device will not print. If you receive this message, you might need to clean the electrical contacts on the printheads and in the device.

CAUTION: Clean the electrical contacts only after you have attempted to clean the printheads. Electrical contacts contain sensitive electronic components that can be damaged easily. For more information, see To clean the printheads.

1.Open the top cover.

2.If the carriage does not move to the left automatically, press and hold the OK button for five seconds. Wait for the carriage to stop moving, and then unplug the power cord from the printer.

Maintain the printheads

147

Page 151
Image 151
HP PRO L7500 To calibrate the linefeed, To clean the printheads, To clean the printhead contacts manually