Solid-state drive

Description

Spare part number

 

 

256-GB

716749-001

 

 

128-GB

716748-001

 

 

Before removing the solid-state drive, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 33).

5.Remove the service cover (see Service cover on page 34).

Remove the solid-state drive:

1.Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the computer. (The solid-state drive tilts up.)

2.Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.

Reverse this procedure to install the solid-state drive.

40

Chapter 4 Removal and replacement procedures