*
*INITIALIZATION PHASE
LINKS,CP ,Use current page linking
* | SYSTEM RELOCATION PHASE (Use one of the following RPLs) |
* |
|
* |
|
*###################################################################
* | # |
| # |
* | # | If you use an RPL file for a hardware configuration with | # |
*# fewer features than yours, your system will not be performing #
* | # | as well as it could. You may not use an RPL file for a | # |
* | # hardware configuration with more features than yours. | # | |
* | # |
| # |
* | # Choose the correct RPL file for your system from the | # | |
* | # | choices below and remove the ”*” in front of it. | # |
* | # |
| # |
*###################################################################
* |
|
|
| DOUBLE PRECISION |
* | RPL FILE | PROCESSOR TYPE | CDS | FLOATING POINT |
* | ||||
*re | /rte_a/%rpl40,, | A400 | NO | NO |
*re | /rte_a/%rpl41,, | A400 | NO | YES |
*re | /vcplus/%rpl42,, | A400 | YES | NO |
*re | /vcplus/%rpl43,, | A400 | YES | YES |
*re | /rte_a/%rpl60,, | A600 | NO | NO |
*re | /rte_a/%rpl61,, | A600+ | NO | YES |
*re | /vcplus/%rpl63,, | A600+ | YES | YES |
*re | /rte_a/%rpl70,, | A700 | NO | NO |
*re | /rte_a/%rpl71,, | A700 | NO | YES |
*re | /vcplus/%rpl72,, | A700 | YES | NO |
*re | /vcplus/%rpl73,, | A700 | YES | YES |
*re | /rte_a/%rpl90,, | A900 | NO | YES |
*re | /vcplus/%rpl91,, | A900 | YES | YES |
*re | /rte_a/rpl_a990.rel,, | A990 | NO | YES |
*re | /vcplus/rpl_a990_cds.rel,, A990 | YES | YES | |
* |
|
|
|
|
*###########################################################
* | # | # |
* | # For A900 with either NS/1000 or %envrn, choose either | # |
* | # rpl_a900_rev4.rel (rev.4 firmware or later) or | # |
* | # xmb.rel (pre rev.4 firmware) | # |
* | # | # |
*###########################################################