HP T200 manual Charge your battery, Inserting and Removing an SD Card Optional

2.3 Charge your battery

It is recommended that the AC adaptor and USB cable included with the camcorder be used for the initial charge.

The camera must be turned OFF; a blinking light confirms charging, and the light becomes constant when the charging has been completed.

In AC charging Mode, the light will turn itself off automatically after a short time. The full charge time is about 3 to 4 hours. (Actual charging time may vary depending on the condition of the battery.)

2.4 Inserting and Removing an SD Card (Optional)

Although the camera comes with internal memory which allows a limited number of photos and video to be recorded, it is strongly recommended that you expand the capacity by using SD/SDHC memory cards.

1.Insert the memory card into the slot. Please refer to the figure to the right.

2.To remove an installed SD card, press the card

inwards to release it.

3.When the card pops out, gently remove it from its slot.

4.Recommended memory capacity: 1GB or

above.

Note

•When a memory card is installed, videos/photos are saved on the card rather than on the built- in memory.

•Protecting Data on an SD Card: SD Card is read-only when it is locked. No photos or videos can be recorded when the SD card is locked. Make sure the lock is on the writeable position before recording any media.

Writeable Write-Protected

positionPosition

9