Display assembly

Description

Spare part number

 

 

12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, fingerprint reader,

464144-001

microphones, and WLAN antenna cables

 

 

 

12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, microphones, and

464142-001

WLAN antenna cables

 

 

 

12.1-inch, WXGA, BrightView touch-screen display assembly with fingerprint reader, microphones and

464145-001

WLAN antenna cables

 

 

 

12.1-inch, WXGA, BrightView touch-screen display assembly with microphones and WLAN antenna

464143-001

cables

 

 

 

Before removing the display assembly, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power cord.

4. Remove the battery (see Battery on page 36).

5. Remove the memory module compartment cover (see Memory module on page 41).

6. Remove the WLAN module compartment cover and disconnect the wireless antenna cables from the WLAN module (see WLAN module on page 43).

7. Remove the keyboard (see Keyboard on page 47).

8. Remove the switch cover (see Switch cover on page 49). Remove the display assembly:

1. Close the computer and turn it upside down, with the front toward you.

2. Loosen the Phillips PM2.0×5.0 captive screw (1) that secures the display connector cover to the computer.

3. Lift the rear edge of the display connector cover (2) and swing it toward you.

4. Remove the display connector cover.

NOTE: The display connector cover is included in the Plastics Kit, spare part number 464114-001.

Component replacement procedures 51