i. System board (see System board on page 60)

j. Pen holder (see Pen holder on page 63)

Remove the audio/infrared board:

1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the audio/infrared board to the system board.

2. Release the audio/infrared board (2) by sliding it away from you until the connectors on the front of the board disengage from the openings in the base enclosure.

3. Remove the audio/infrared board (3).

Reverse this procedure to install the audio/infrared board.

Component replacement procedures 65

Page 73
Image 73
HP tx2000 manual